16 September 2023, 08:00
Hey, its been a while since my last post, hope everyone is well. Car stats at bottom of post.
The last few weeks I've been running real warm with the occasional boil over. Seemingly out of the blue. In an attempt to diagnose I've been taking temp reading
Source:
All Ford Mustang News
0
16 September 2023, 08:00
to start off I installed an Exedy Mach 400 Stage 2 clutch, new flywheel, pilot bearing, and new throwout bearing. I have a noise at idle, when my A/C is set to Max A/C, coldest setting, and blower speed 2, however it goes away when the clutch pedal is ful
Source:
All Ford Mustang News
16 September 2023, 08:00
PCM "Connector Views" missing from Service Manual - Upstream O2 pinouts please
I data logged my upstream O2 sensors today and the driver's side one is completely flatlined (Bank2 sensor1). It's a new sensor. I verified that the Violet-Grey wire is supp
Source:
All Ford Mustang News
16 September 2023, 08:00
I'm getting ready to replace my timing stuff and I just hate to put those cheap plastic BS timing chain tensioners back into my 05 gt. MMR has a pair of metal tensioners with the ratchet design and they list them as UPGRADED tensioners. I called them to
Source:
All Ford Mustang News
16 September 2023, 08:00
I need some guidance, I have a 2007 V6 mustang (it had a 93 octane preloaded SCT X4 tune, and cold air intake, everything else stock). I wanted to get a muffler delete so I went to Midas and they straight piped muffler back (all they did was remove muffle
Source:
All Ford Mustang News
15 September 2023, 08:00
Does anyone know what these go to? I’ve had the car apart for a while and finishing putting it back together….. like a dummy I didn’t label everything because I figured it would be obvious where certain things go. For the life of me I can’t see what these
Source:
All Ford Mustang News
15 September 2023, 08:00
Motorcraft doesn't make the upstream o2 sensor for my 2006 mustang gt anymore but says the downstream o2 sensor will work. I've replaced the o2 sensor with three different Motorcraft part #dy-1401 and I get the code that says slow response from that o2 se
Source:
All Ford Mustang News
15 September 2023, 08:00
I bought some GT exhaust tips and trim rings today for my 66 mustang
I want to try and cut holes for the trim rings into my Non-GT rear valance. Anyone done this successfully? any tips or problems trying to cut the holes.
I am thinking about doing to do t
Source:
All Ford Mustang News
15 September 2023, 08:00
My wife and I sold her Kia Stinger.... super fun car by the way. When we bought the stinger we picked up these wheels at the dealer for winter tires. Now that the car is sold I popped them on my blue gt/cs and think they could work. The rims were always b
Source:
All Ford Mustang News
15 September 2023, 08:00
New to forum, 1st Mustang! Been waiting a long time for this and very happy car is a blast to drive. Looking forward to taking to the track. Any info on the car will always be welcomed.
Source:
All Ford Mustang News