19 June 2024, 08:00
Good day all, new member out of NC and needing some assistance if you can. Back in 2012, while station in Tucson AZ, I let this beauty slip away and I have been regretting it ever since. 2007 GT Premium with a modest host of upgrades. I was the origina
Source:
All Ford Mustang News
0
19 June 2024, 08:00
here is what I got
when accelerating from stop (normal accelerating not flooring it)
the car starts moving, rpm jumps higher but the speed of acceleration doesn't change and then it shifts to next gear and jerks
Almost as if I was pressing the clutch and
Source:
All Ford Mustang News
18 June 2024, 08:00
Hey all. Long story short just recently dropped some junk into the pcv opening on the drivers side valve cover so it had to come off to prevent any damage to the engine. I finally got the cover off and now am replacing the gasket (car has 144k miles and I
Source:
All Ford Mustang News
18 June 2024, 08:00
What would you recommend for a standard tune up? It's got 41,000 miles on it and hasn't been driven more than 5000 miles in the last 12 years. It has sit for the last year and a half and barely started. I know it isn't up to par and it developed a miss af
Source:
All Ford Mustang News
18 June 2024, 08:00
Hello friends, I changed the color of my V6 2015 Ford Mustang Convertible vehicle. I painted my vehicle with new wheels and black parts with piano black paint, applied some body kit to my vehicle and modified it a little. My vehicle is 92000 km and clean
Source:
All Ford Mustang News
18 June 2024, 08:00
Got the car started for the first time and it's running OK. Had a slight hesitation off idle but I suspect I know why that is happening. Turns out the PO had cut the wires to the Camshaft Position Sensor for some reason. Just picked up a new sensor and
Source:
All Ford Mustang News
17 June 2024, 08:00
Good afternoon, I'm searching for help with my 1995 mustang GT convertible. I was using the top yesterday and everything was fine. Today I went to put the top up(dropping it off for service)and nothing. I tried pulling the E brake up harder in case for so
Source:
All Ford Mustang News
16 June 2024, 08:00
So, I just purchased a 1967 mustang(6 cylinder). The front brakes have disc brakes and the rear brakes are drums. The brakes are working just fine up until recently one of the calipers got stuck and started grinding the rotors. i took it to Napa auto part
Source:
All Ford Mustang News
16 June 2024, 08:00
I recently bought an 06 mustang 4.0 V6, I drove the car Saturday evening, and when I went to start it Sunday it would crank but would not start. Replaced the plugs and wires and the cool pack and the car ran, took it down the road, let it run for about 15
Source:
All Ford Mustang News
16 June 2024, 08:00
So I’m looking into replacing the MAF on my 07GT and I was just wondering if anyone had any recommendations on a sensor and ways to seal it to my intake I have a JLT series 3 and I can’t find that rubber gasket anywhere and I know right now that mine is b
Source:
All Ford Mustang News