22 May 2023, 08:00
Ok, so now that the afterglow of dyno day has worn off, I’m looking at my numbers a little more skeptically…
02 4.6 2v 133k Miles
P1SC-2, 3.9 pulley, 3 core cooler, Power Pipe
C&L plenum, 78mm TB
Long tubes, orx pipe, magnapack catback
91 Octane
Hones
Source:
All Ford Mustang News
0
22 May 2023, 08:00
My 65 mustang has developed a braking issue. When applied quickly and hard only the right front wheel started to lock. When the pedal is released everything is fine again. Normal gradual braking works fine. This condition just developed and only is when y
Source:
All Ford Mustang News
22 May 2023, 08:00
So right now I have a stock exhaust. I have been wanting a new exhaust for a while now, and today I found a Magnaflow x pipe with Flowmaster super 44 mufflers on craigslist for $300. I have seen videos on youtube and I'm wondering if this set up is going
Source:
All Ford Mustang News
22 May 2023, 08:00
So after installing a new alternator i found several issues with the battery wire harness. So I purchased a brand new factory battery harness from the dealer but it is missing 1 very important wire. Can anyone please help me to where I can find purchase
Source:
All Ford Mustang News
22 May 2023, 08:00
Greetings. Any dealers (preferably in the SE US) ordering a Dark Horse at MSRP? The local dealer I contacted wanted $15k over MSRP.
Source:
All Ford Mustang News
21 May 2023, 08:00
Waahhhhhh ❤. HA, I'm 73 and just bought my first MUSTANG. I was waiting to win the lottery but time is running out. Better late than never. I'm LOVING ❤ it. Enjoy the ride cause I sure am.
Source:
All Ford Mustang News
21 May 2023, 08:00
Can anybody help me figure out some more information on my motor. So I found my casting numbers and from what I can tell it’s a 302 block from 1978. D8VE-6015-A3A my lifter valley has no markings other than a “25” casted into the center. If anybody can sh
Source:
All Ford Mustang News
21 May 2023, 08:00
Hey everyone! I have a 1968 Mustang with what I believe is a 1991 EFI mustang conversion with the original block still being used.
I did not perform the conversion and since had a few issues with it. Sent to someone who “knew” what they were doing.
Source:
All Ford Mustang News
21 May 2023, 08:00
On the 68, 289 2bbl mustang I am working on I had to cut the belts off when I got it. Looking at the Power steering pulley it does not look like it was aligned properly with the outer pulley ( the inner appears to be for the Alternator). Is it possible
Source:
All Ford Mustang News
21 May 2023, 08:00
I've been tracing down a pretty significant voltage drop on my volt meter that occurs any time I switch certain loads on, such as the blower, radio, etc. To rule out a faulty volt meter on my aftermarket gauge cluster, I measured the voltage at the contro
Source:
All Ford Mustang News