23 September 2020, 08:00
Hi fellas and ladies,My name is Kevin and i am working on a 70 Mach1 and was wondering if someone could post a pic of the clips that attach the rocker molding to the rockers?I really appreciate any help so thankyou in advance.
This is a pic its not perfe
Source:
AllFordMustangs
0
22 September 2020, 08:00
Hi folks,
I had an 06 Mustang V6 for a bunch of years, and in May, found myself the 09 GT I'd been longing for. 31k miles, everything works perfectly. Terrific car. Today is the first issue though:
I got about a couple hundred yards down the road and
Source:
AllFordMustangs
22 September 2020, 08:00
Has anyone found a good way to stop heat entering from trans tunnel on C4 Auto transmission shiftier in a 65 Mustang. None listed as new / replacement, Looking for a way to DIY type insulator.
Does a 65, 4 or 5 speed lower shiftier fit the holes for
Source:
AllFordMustangs
22 September 2020, 08:00
My friend absolutely swears he will beat my 14 5.0 I have lund 93 tune , drop in kn air intake and full straight catless exhaust, I’m probably ball park 410 wheel, my friends fox body is the stuff below but he IS NOT RUNNING NOS
Source:
AllFordMustangs
22 September 2020, 08:00
I recently bought a 2014 Mustang GT with coilovers on it. It was slammed to the ground, but I told the dealership if they raise it up all the way, I would buy it. So the raised it up maybe a inch and said that’s the highest they can go. It was fine until
Source:
AllFordMustangs
22 September 2020, 08:00
So I just purchased my 2012 GT vert and when I bought it, I knew that the back window was not completely sealed with the convertible top. I thought it would be an easy fix, but after visiting several shops they all say the same thing, replace the top bec
Source:
AllFordMustangs
22 September 2020, 08:00
Hi all,
Recently I got a noise problem in my GT. It started suddenly, while I was driving. I wasn't accelerating hard or hit any pothole, just normal drive and it started.
Problems is about rumble/hollow noise from the front part of the car (somewhere a
Source:
AllFordMustangs
22 September 2020, 08:00
I'm looking towards swapping my 07 GT for a 4V in the near future. I've always been planning on getting a Mach 1, but have been thinking about the IRS recently.
Does the IRS actually make a difference in ride quality on the street? I'm not going to be tr
Source:
AllFordMustangs
22 September 2020, 08:00
Hii so I’m new with this, I have a 2000 mustang with a 3.8, when I replaced my headers my old egr tube striped out and I can’t get it back on, well when I went to get another one I can’t seem to find one anywhere. So now I just wanna bypass the DPFE senso
Source:
AllFordMustangs
22 September 2020, 08:00
I'm removing the K-member from my 2002 GT, because I'm rebuilding my entire front/rear suspensions, and I'm also replacing my oil pan/gasket (the primary reason for the K-member removal). As far as rebuilding my front suspension, I'm retaining the stock c
Source:
AllFordMustangs