31 May 2024, 08:00
Hello all,
I have a 2008 Mustang GT convertible, when I purchased it the horn did not work, the airbag light was on, the cruise worked, power mirrors did not work.
I replaced the clock spring, airbag light is out, but the rest remains. I bought a used BCM
Source:
All Ford Mustang News
0
31 May 2024, 08:00
So I have an 07 GT, I swapped Coils #3 & #4 as well as changed the Cylinder #4 Sparkplug (I plan on going a step-colder for a procharger so just doing this as a way to check possible issues off the list.) and the misfire did not swap cylinders.
What are
Source:
All Ford Mustang News
31 May 2024, 08:00
Long story short my 2005 Mustang GT sat for about a year after the A/C went out in it... So we just replaced the compressor, dryer, both switches, a burnt connector to one of the switches, fuse #49 and mini relay #24 but the A/C clutch still will not enga
Source:
All Ford Mustang News
31 May 2024, 08:00
Car is a 2014 Mustang GT, everything is stock except the exhaust which is a MBPR . Had a code come up on the CEL which was P2096. My car would also stall out at a stop light on longer drives. I decided to get aftermarket Downstream O2 sensors and swap the
Source:
All Ford Mustang News
31 May 2024, 08:00
Hey all. Long story short just recently dropped some junk into the pcv opening on the drivers side valve cover so it had to come off to prevent any damage to the engine. I finally got the cover off and now am replacing the gasket (car has 144k miles and I
Source:
All Ford Mustang News
30 May 2024, 08:00
Hi everyone, I’m looking at buying a 2014 Ford Mustang Premium with the Pony & Comfort packages. It has a 305 hp V6 and 42k original miles. The seller got it from the original owner two years ago when it had 37K miles. Since then, he put on new tires and
Source:
All Ford Mustang News
30 May 2024, 08:00
So on my 07 whenever I turn on the AC the 1-3 settings all work. Whenever I turn it over to 4 it blows the tiniest amount of air similar to setting 1 any causes, fixes, or a diagnostic process I should take?
Source:
All Ford Mustang News
30 May 2024, 08:00
We had somebody put fat double matte racing stripes with pinstriping on the car, from nose to tail, a few years ago. The pin striping is whats cracking. Would it be better to either re-pinstripe it or paint the stripes on. If you had it done, how much?
Source:
All Ford Mustang News
30 May 2024, 08:00
I have a squeak in my pulley system and I’ve changed the tensioner pulley and the idlers pulley and there’s a new water and power steering pump and I realized the squeak is due to a alignment issue with the pulley what is the size of the serpentine belt I
Source:
All Ford Mustang News
30 May 2024, 08:00
I have a 00 v6 with a 7.5 inch rear end. My wheel bearings are going bad and I plan on replacing them but need to find the parts. Do the 7.5 and the 8.8 share the same bearings and axle seals for my year?
Source:
All Ford Mustang News